V-Die Opening Calculator

Calculate the recommended press brake V-die opening width, safe tooling range, natural air bend radius, and minimum required flange length.

Tooling Selection Results

Recommended V-Die Opening (V)
24.00 mm
Safe Tooling Range 18.0 mm – 30.0 mm
Natural Formed Inside Radius (Ri ≈ 0.16V) 3.84 mm
Minimum Flange Return (b_min ≈ 0.7V) 16.80 mm
V-Die Tooling Profile 8× Rule
Ri ≈ 0.16V V-Die Width (V) b_min ≈ 0.7V
Standard Heuristic: V = 8 × T • Ri ≈ 0.16 × V • b_min ≈ 0.7 × V

How to Select the Correct Press Brake V-Die Opening

01

Check Material Thickness

Measure incoming mill sheet thickness (T). V-die selection directly controls both tonnage load and formed inside radius.

02

Apply the 8× Rule

For standard mild steel sheet under 3 mm, select a V-die width equal to 8 times the material thickness (V = 8 × T).

03

Verify Minimum Flange

Ensure your blueprint flange length exceeds b_min ≈ 0.7 × V so the workpiece does not slip down into the die cavity.

04

Check Natural Radius

In air bending, the inside radius naturally forms to ~16% of V. Verify this matches your drawing specification.

Standard V-Die Rules of Thumb

Thickness Range Recommended Die Ratio Natural Inside Radius
T < 3 mm (Sheet)6× to 8× TRi ≈ 0.16 × V
3 mm ≤ T ≤ 8 mm8× to 10× TRi ≈ 0.16 × V
T > 8 mm (Plate)10× to 12× TRi ≈ 0.18 × V

Shop Floor Tooling Rules

💡 Prevent Flange Drop-in: If your drawing has a short flange shorter than 0.7 × V, you must switch to a smaller V-die (and verify machine tonnage) or use a specialized rotary-wing die.
⚠️ Tooling Friction Marking: When air bending cosmetic aluminum or polished stainless, use hardened roller-shoulder V-dies or protective polyurethane die film to prevent galling scratches.

Frequently Asked Questions (FAQ)

Why does the inside bend radius depend on the V-die opening rather than the punch?

In standard air bending, the workpiece sheet only contacts the tool at three points: the punch nose tip and the two bottom die shoulders. As the punch descends into empty space, the sheet naturally forms a parabolic curve whose radius is approximately 15% to 17% of the die opening width.

What happens if I use a V-die that is too small?

Using a die opening below 6× thickness dramatically increases required bending tonnage, risks overloading the machine or cracking the tooling shoulders, and increases sheet surface marking.

Engineering Disclaimer: V-die opening calculations are based on standard air bending practices. When bottoming or coining, tooling manufacturer tonnage ratings must be consulted.