Sheet Metal Bend Radius Calculator

Calculate the minimum safe inside bend radius, recommended radius, and cracking risk based on alloy temper and rolling grain direction.

Radius Results

Minimum Safe Inside Radius (R_min)
1.00 mm
Recommended Tooling Radius 2.00 mm
Cracking Risk Level Low Risk (Safe)
Grain Direction & Cracking Metallurgy
Mill Rolling Direction ➔ Across Grain (Transverse) ✓ Best ductility (R_min ≈ 0.5T–1T) With Grain (Longitudinal) ⚠️ Crack risk (R_min ≈ 1.5T–3.5T)
Metallurgical Rule: Bending across the grain maximizes plastic ductility; bending along the grain opens micro-cracks.

How to Select Minimum Inside Bend Radii

01

Identify Alloy & Temper

Material temper is critical. For example, 5052-H32 aluminum bends tightly, while precipitation-hardened 6061-T6 fractures easily.

02

Orient to Grain Line

Whenever possible, orient the bend line at 90° (transverse) to the sheet rolling direction to prevent outer fiber tearing.

03

Select Punch Nose Radius

Ensure your press brake punch nose radius is greater than or equal to R_min to prevent sharp knife-edge creasing.

04

Inspect Outer Bend Surface

Inspect bent parts under magnification for orange-peel texture or micro-fractures along the tensile outer radius.

Minimum Inside Bend Radius Guidelines

Material & Temper Across Grain (Transverse) With Grain (Longitudinal)
Mild Steel (A36 / 1008)0.5 × T1.0 × T
Stainless Steel 3041.0 × T1.5 × T
Aluminum 5052-H321.0 × T1.5 × T
Aluminum 6061-T62.0 × T to 3.0 × T3.5 × T to 4.5 × T

Preventing Aluminum Cracking

💡 45-Degree Laser Nesting: If an enclosure requires bends along both perpendicular axes, nest the flat blanks at 45° to the sheet rolling direction so neither bend runs parallel to the grain.
⚠️ Annealing Hard Alloys: If 6061-T6 aluminum must be formed around a tight 1T radius, preheat or locally anneal the bend line to an O-temper state prior to pressing.

Frequently Asked Questions (FAQ)

What causes "orange peel" texture on bent sheet metal?

Orange peel texture occurs when the outer surface of the metal is stretched close to its plastic strain limit. The grain boundaries slide and rotate, producing a rough pebbled appearance that precedes full cracking.

Can I bend sheet metal to a sharp zero inside radius (R = 0)?

No. Physical sheet metal always requires a finite radius. Attempting a zero-radius bend acts as a knife edge, shearing the internal grain structure and creating a high stress-concentration crack initiation site.

Engineering Disclaimer: Minimum bend radii depend on exact mill heat ductility and grain elongation. Check mill test reports (MTR) before forming flight-critical components.