Press Brake Tonnage Calculator

Calculate the estimated press brake bending force in kN, Metric Tons, and US Short Tons for air bending, bottoming, and coining operations.

Tonnage Results

Total Required Force
15.20 Metric Tons
US Short Tons (2000 lb) 16.76 US Tons
Force in Kilonewtons (kN) 149.10 kN
Force per Meter of Bend (t/m) 15.20 t/m
Press Brake Tooling Force Air Bending
Punch Force (F) Sheet (T) Lower V-Die Block Die Opening (V)
Empirical Air Bend Formula: F = (1.42 × UTS × L × T²) / (1000 × V)

How to Calculate Press Brake Bending Tonnage

01

Select Material Alloy

Choose material from the dropdown to load certified Ultimate Tensile Strength (UTS in MPa or ksi), or enter your custom mill test value.

02

Input Thickness & Length

Enter actual sheet thickness (T) and the total formed bend line length (L). Note that force scales linearly with bend length.

03

Select V-Die Opening

Input your lower V-die opening width (V). Standard practice is 8× thickness for sheet up to 3 mm, and 10× to 12× for thicker plate.

04

Review Machine Safety

Verify that required tonnage and tonnage per meter (t/m) do not exceed the press brake centerline rating or tooling load limits.

Empirical Tonnage Formulas & Methods

Press brake force is inversely proportional to die opening width (V) and proportional to the square of sheet thickness (T²). Doubling sheet thickness quadruples the required tonnage.

Standard Air Bending Formula:
F (kN) = [1.42 × UTS(MPa) × L(mm) × T²(mm)] / [1000 × V(mm)]
Force (Metric Tons) = F (kN) / 9.80665
Force (US Tons) = Force (Metric Tons) × 1.10231

For bottoming, multiply air bend force by 3× to 5×. For coining, multiply air bend force by 5× to 8×.

Machine Limits & Safety Rules

💡 Prevent Centerline Ram Upset: Never exceed your press brake maximum load per meter (e.g., 100 tons/meter). Bending short, thick brackets at full machine tonnage in the center of the bed will permanently bow the upper ram.
⚠️ Tooling Shoulder Fracture Risk: Using an undersized V-die (V < 6 × T) concentrates extreme localized stress on the die shoulders, risking brittle tooling explosion.

Frequently Asked Questions (FAQ)

How does stainless steel tonnage compare to mild steel?

Stainless steel (such as 304 or 316) has an ultimate tensile strength of approximately 600–650 MPa, compared to 420 MPa for mild steel. As a result, stainless steel requires approximately 50% more bending tonnage than carbon steel of the same thickness.

How can I reduce required press brake tonnage on thick plate?

Increase the bottom V-die opening width. Because tonnage is inversely proportional to die width (1/V), opening the die from 8× thickness to 12× thickness reduces required tonnage by 33%.

Engineering Disclaimer: Tonnage formulas provide empirical estimates for air bending. Tool friction, lubrication, rolling grain, and actual alloy chemistry cause ±10% variation. Check machine and tooling manufacturer load charts before maximum-capacity bends.