Sheet Metal Springback Calculator

Estimate the elastic springback angle (Δθ) and CNC press brake overbend compensation target angle based on yield strength and Young's modulus.

Springback Results

Estimated Springback (Δθ)
1.08°
CNC Machine Overbend Target 91.08°
Springback Factor (Ks) 0.988
Required Tooling Angle 88.9° or 85° Die
Elastic Angular Recovery Overbend
Loaded (Overbent) Released (Target) Δθ (Springback) CNC Overbend Rule: Program angle to 90° + Δθ Use acute (85°/88°) tooling
Mechanical Principle: Δθ ∝ (Yield Strength / Modulus E) × (R / T)

How to Compensate for Sheet Metal Springback

01

Identify Yield & Modulus

Springback is driven by the ratio of Yield Strength to Elastic Modulus (σy / E). High-strength aluminum and stainless spring back dramatically.

02

Input R / T Ratio

Enter inside bend radius and thickness. Large bend radii on thin sheet (R/T > 4) exhibit significantly higher springback than tight bends.

03

Calculate Overbend Angle

Click Calculate to determine the required CNC press brake stroke depth and target overbend angle (e.g. 91.5° to finish at 90.0°).

04

Select Acute Tooling

Verify that your punch and V-die angles are acute enough (e.g., 85° or 88°) to permit overbending without bottoming out the tool.

Elastic Recovery Physics & Formulas

When the press brake ram releases pressure, the elastic stresses locked within the material cross-section spring back to equilibrium. The springback factor Ks is defined as:

Springback Factor Equation:
Ks = [ 4 × (R × σy / (E × T))³ − 3 × (R × σy / (E × T)) + 1 ]⁻¹
Δθ = θ_target × (1 − Ks) / Ks
Overbend Target = θ_target + Δθ

Shop Floor Springback Solutions

💡 Bottoming to Eliminate Springback: If an older manual press brake cannot control overbend depth, bottom bending or coining will stamp the material past its elastic memory, reducing springback to near zero (requires 4× tonnage).
⚠️ Aluminum 6061-T6 Alert: Due to its low elastic modulus (69 GPa) and high yield strength (276 MPa), 6061-T6 aluminum springs back 3× to 4× more than mild steel.

Frequently Asked Questions (FAQ)

Why do air bent parts spring back more with larger inside bend radii?

When the bend radius is large relative to sheet thickness (high R/T), a larger proportion of the cross-section remains within the elastic stress zone rather than undergoing permanent plastic deformation. Therefore, the part releases more elastic energy upon unloading.

How do modern CNC press brakes automatically compensate for springback?

Modern CNC press brakes feature laser or mechanical angle measuring systems (e.g. Lapis, Easy-Form) that measure the bent angle under load, release ram pressure to measure elastic recovery, and automatically re-stroke to the exact compensated depth in a single cycle.

Engineering Disclaimer: Springback angle calculations provide theoretical estimates. Actual sheet springback varies between mill rolling lots, cold-work history, and machine deflection. Calibrate on the production machine.